Thin hydraulic cylinder HT

The so-called super thin hydraulic cylinder can also be said to be super thin jack, as the name suggests is lower than the ordinary hydraulic cylinder relative thickness, with light weight, large tonnage, mobile flexible characteristics.The mounting hole makes fixing easy and the baking surface makes the corrosion resistance stronger.
send email to us

Products Details

Tpye Double Acting Double Acting Both Sided Rod
Bore Φ32.Φ40.Φ50.Φ63.Φ80.Φ100.(Φ125) Φ32.Φ40.Φ50.Φ63.Φ80.Φ100.(Φ125)
Max.Working Press l40kgf/cm2(13.729Mpa)
Allow Press 210kgf/cm2 (20.594Mpa)
Min.Working Press 3~8kgf/cm2
Range Of Speed 8~100mm/sec
Working Temp 10~+80℃
Apply Working Oil Commonly Mineral Oil
Screw Tolerance Of Rod KSB0214 2 Class
Stroke Tolerance 0~+0.8mm
Supporting Type Basic Type
※Using Press Over140kgf/cm2 Plseas Inquire Us  

※UsingTemp Over 100,Please Inquire Us

  

※With Switch Can Order(Please Inquire Us)

  
※With Switch Type.The Dimension Of R Will Changer  
The ultra-thin hydraulic cylinder is equipped with a handle that is easy to carry. It is mainly used in the narrow space and has good operation ability in the small space of the construction site.It is smaller than the ordinary hydraulic cylinder, and can be operated remotely by connecting the high pressure hose with the thin top. The separated structure is very convenient for the repair and maintenance of the hydraulic top. Tips for using ultra-thin hydraulic cylinder: First of all, before use must check the hydraulic cylinder parts are normal. Second, the weight center of gravity to choose moderate, reasonable selection of hydraulic cylinder force point, bottom pad flat, at the same time to take into account the ground soft and hard conditions, whether to pad tough wood, placed smoothly, so as to avoid weight subsidence or tilt. Third, when using ultra-thin hydraulic cylinder, first connect the quick joint of the manual pump to the top, then select the right position, tighten the oil discharge screw on the oil pump, and then it can work.To make the piston rod drop, loosen the hand pump wheel slightly counterclockwise and the cylinder will be unloaded. Then the piston rod will drop gradually.Otherwise it will be dangerous to fall too fast. Fourth, after the hydraulic cylinder will be heavy lifting, the weight should be supported in a timely manner firmly, it is prohibited to use ultra-thin hydraulic cylinder as a support. Fifth, the user in the use of the hydraulic cylinder should strictly abide by the main parameters of the provisions, avoid super-high overload, otherwise when the lifting height or lifting tonnage exceeds the provisions, the top of the cylinder will occur serious oil leakage. Safety tip: If the user needs several hydraulic cylinders to be lifted at the same time, in addition to the correct placement of ultra-thin hydraulic cylinders, multi-top shunt valves should be used, and the load of each hydraulic cylinder should be balanced, pay attention to keep the lifting speed synchronous.It is also necessary to take into account the possibility that the ground may cave in due to uneven weight to prevent the weight being lifted from tilting and causing hazards.

Previous:Factory-Direct Vacuum Filters for Clean and Efficient Homes

Next:Metal-polymer self-lubricating bearings

Hot rolled steel tube, Filter Regulator Unit, Miniature Oscillating Cylinder, Ceramic Vacuum Chuck, Pilot Operated 3 Way Sol. Valve, Large excavator cylinder, Small Hole Guage, Bore Guage, Threaded Five-Way Screw Pipe, Heavy equipment hydraulic cylinder,

Featured Products

Contact us

Please feel free to give your inquiry in the form below We will reply you in 24 hours